Throttle Position (TP) Sensor

Disconnect negative battery cable and TP sensor connector. See Fig 1 . Using an ohmmeter, check resistance between indicated terminals. See THROTTLE POSITION (TP) SENSOR RESISTANCE table.
If resistance is not as specified, adjust TP sensor. See ADJUSTMENTS article. If resistance is not as specified after adjustment, replace TP sensor. For further diagnostic procedures, see TESTS W/CODES article.

THROTTLE POSITION (TP) SENSOR RESISTANCE

Application

Ohms

Between Terminals "A" & "C"

⁽¹⁾ 100-20,000

Between Terminals "A" & "D"

2870-5330

⁽¹⁾	Varies with throttle position.

Fig 1: Throttle Position (TP) Sensor Terminals

Courtesy of GENERAL MOTORS CORP.