Transmitter Programming Procedure

IMPORTANT: Turn the ignition to ON before installing in the scan tool. Failure to connect in this procedure may cause communication errors and the programming procedure will not complete. Any keys that are not programmed at this time will no longer function.
1. Turn ON the ignition with the engine OFF.
2. Install the scan tool.
3. Select PROGRAMMING KEY FOBS from the BODY menu.
4. Follow the scan tool instructions with each key until all keys are programmed.
5. Turn the ignition to the LOCK position, disconnect the TECH 2 and test all the keys.
6. If any key does not function, refer to Keyless Entry Does Not Program .

For immobilizer programming, refer to Programming Additional Keys in Theft Deterrent System