LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTC P0221 Through P0459 >> DTC P0324: Knock Sensor (KS) Module Performance >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING CHART

Step Action Value (s) Yes No
1 Did you perform the DIAGNOSTIC SYSTEM CHECK ? - Go to Step 2. Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
2
  1. Observe the Freeze Frame / Failure Records for this DTC.
  2. Turn the ignition OFF for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Setting the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame / Failure Records.

Did the DTC fail this ignition?
- Go to Step 3. Go to Intermittents .
3 Replace the ECM.
Did you complete the replacement?
- Go to Step 4. -
4
  1. Clear the DTCs with a scan tool.
  2. Turn the OFF ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Setting the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame / Failure Records.

Did the DTC fail this ignition?
- Go to Step 2. Go to Step 5.
5 Check if any additional DTCs are set.
Are there any DTCs that have not been diagnosed?
- Go to applicable DTC Table . System OK