A/T System Check: Notes

Refer to the following items for the details of each step.

DIAGNOSTIC INFORMATION TABLE

Step	Action	YES	NO
1	Customer complaint analysis Perform STEP 1. CUSTOMER COMPLAINT ANALYSIS . Was customer complaint analysis performed?	Go to Step 2.	Perform STEP 1. CUSTOMER COMPLAINT ANALYSIS .
2	DTC / freeze frame data check, record and clearance Check for DTC (including pending DTC). Is there any DTC(s)?	Print DTC and freeze frame data or write them down and clear them by referring to DTC CLEARANCE . Then go to Step 3.	Go to Step 4.
3	Visual inspection Perform VISUAL INSPECTION . Is there any faulty condition?	Repair or replace malfunction part. Then go to Step 11.	Go to Step 5.
4	Visual inspection Perform VISUAL INSPECTION . Is there any faulty condition?	Repair or replace malfunction part. Then go to Step 11.	Go to Step 8.
5	Trouble symptom confirmation Confirm trouble symptom. Is trouble symptom identified?	Go to Step 6.	Go to Step 7.
6	Rechecking and recording of DTC/freeze frame data Recheck for DTC and freeze frame data referring to DTC CHECK . Is there any DTC(s)?	Go to Step 9.	Go to Step 8.
7	Rechecking and recording of DTC/freeze frame data Recheck for DTC and freeze frame data referring to DTC CHECK . Is there any DTC(s)?	Go to Step 9.	Go to Step 10.
8	A/T basic check and A/T symptom diagnosis Check and repair according to A/T BASIC CHECK and A/T SYMPTOM DIAGNOSIS . Are check and repair completed?	Go to Step 11.	Check and repair malfunction part(s). Then go to Step 11.
9	Troubleshooting for DTC Check and repair according to applicable DTC flow. Are check and repair completed?	Go to Step 11.	Check and repair malfunction part(s). Then go to Step 11.
10	Check for intermittent problems Check for intermittent problem. Is there any faulty condition?	Repair or replace malfunction part(s). Then go to Step 11.	Go to Step 11.
11	Final confirmation test Clear DTC if any. Perform STEP 11. FINAL CONFIRMATION TEST . Is there any problem symptom, DTC or abnormal condition?	Go to Step 6.	End.