LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> XL7 Base, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

NOTE:
  • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
  • Always route the replacement cable the same way as the original cable.
    Fig 1: Underhood Bussed Electrical Center (UBEC) Cover
    G04843500Courtesy of SUZUKI OF AMERICA CORP.
  1. Remove the battery. Refer to REMOVAL PROCEDURE .
  2. Remove the underhood bussed electrical center (UBEC) cover.
    Fig 2: Removing Positive Battery Cable Terminal Nut From UBEC Stud
    G04843501Courtesy of SUZUKI OF AMERICA CORP.
  3. Remove the positive battery cable terminal nut (1) from the UBEC stud.
  4. Remove the positive battery cable terminal (2) from the UBEC stud.
    Fig 3: Battery Tray Support Bracket, Positive And Negative Battery Cable Clip
    G04843502Courtesy of SUZUKI OF AMERICA CORP.
  5. Remove the battery box. Refer to REMOVAL PROCEDURE .
  6. Disconnect the positive and negative battery cable clip (3) from the battery tray support bracket.
  7. Disconnect the positive and negative battery cable clip on the side of the battery tray support bracket.
  8. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
    Fig 4: Positive Battery Cable, Engine Wiring Harness Clip And Starter Solenoid Nut
    G04843503Courtesy of SUZUKI OF AMERICA CORP.
  9. Remove the positive battery cable terminal to starter solenoid nut (6).
  10. Remove the positive battery cable from the engine wiring harness clip (3).
  11. Remove the positive battery cable (4) lead from the starter solenoid.
  12. Cut the tape and remove the positive battery cable from the wire loom.
scientia non olet · About LEMON Manuals