Removal Procedure

NOTE:

A NEW fuel tank module seal is necessary each time the fuel tank module is serviced. Obtain a NEW seal prior to beginning this service procedure.

Fig 1: Identifying Fuel Level Sender Unit & Float Electrical Connector

Courtesy of SUZUKI OF AMERICA CORP.

NOTE:

There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The fuel level sender unit and float is NOT the same for each of the fuel pump modules.

Remove the fuel pump module. Refer to REMOVAL PROCEDURE .
Disconnect the fuel level sender unit and the float electrical connector.
Release the retaining tabs and remove the level sensor by sliding up.