ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

1. ECM Reprogramming - Refer to SERVICE PROGRAMMING SYSTEM (SPS) .
2. Idle Learn Procedure - Refer to IDLE LEARN in Engine Controls - 3.6L (LY7).
3. Theft Deterrent - Refer to THEFT DETERRENT CONTROL MODULE PROGRAMMING AND SETUP . The ECM will learn the incoming fuel continue password immediately upon receipt of a password message. Once a password message is received, and a password is learned, a learn procedure must be performed to change this password again. An ECM which has been previously installed in another vehicle will have learned the other vehicle's fuel continue password, and will require a learn procedure after programming to learn the current vehicle's password.
4. Engine Oil Life Remaining - When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
5. Transmission Fluid Life Remaining - When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.