Installation Procedure

Fig 1: Identifying ECM Retainer Clip

Courtesy of SUZUKI OF AMERICA CORP.

Slide the ECM into the retainer until the clips (1) engage the ECM.

Fig 2: Identifying ECM Retainer
Courtesy of SUZUKI OF AMERICA CORP.
Grasp the ECM retainer and slide the retainer forward until the retainer locks against the 4 clips on the battery cover.

Fig 3: Connecting Engine Wiring Harness Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Connect the engine wiring harness electrical connector (2) to the ECM.
Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION .
If a NEW ECM was installed, reprogram the ECM. Refer to ENGINE CONTROL MODULE PROGRAMMING AND SETUP .