Removal Procedure

NOTE:

NEW fuel tank module seals are necessary each time the fuel tank module is serviced. Obtain NEW seals for both the primary and secondary modules prior to beginning this service procedure.

Fig 1: Identifying Fuel Level Sender Unit And Retaining Tabs

Courtesy of SUZUKI OF AMERICA CORP.

NOTE:

There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The fuel level sender unit and float is NOT the same for each of the fuel pump modules.

Remove the fuel pump module. Refer to REMOVAL PROCEDURE .
Disconnect the fuel level sender unit and float electrical connector from the underside of the top of the pump module.
Release the retaining tabs (1, 2) and remove the level sensor by sliding up.