Installation Procedure

Fig 1: Identifying New Primary Fuel Pump Module Assembly

Courtesy of SUZUKI OF AMERICA CORP.

If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to INSTALLATION PROCEDURE .
Insert the new primary fuel pump module assembly (1) with the level sender and the new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.

Fig 2: Identifying Turning Fuel Sender Lock Ring
Courtesy of SUZUKI OF AMERICA CORP.

NOTE:
Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. Do not apply any type of lubrication in the seal groove.

Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
Use the J 45722 in order to install the fuel sender lock ring. Turn the fuel sender lock ring in a clockwise direction.
Connect the wiring harness to the primary fuel pump module and fuel tank pressure sensor.
Install the fuel tank. Refer to INSTALLATION PROCEDURE and INSTALLATION PROCEDURE .