LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> SX4 Base, Automatic CVT >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Program >> Repair Instructions >> Sensor Calibration of ESP® >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

  1. Set steering wheel in straight-ahead position.
  2. Connect SUZUKI scan tool to DLC (1) with ignition switch OFF.

    Special Tool 

    (A): SUZUKI scan tool (SUZUKI-SDT) 

    Fig 1: Connecting Suzuki Scan Tool To DLC
    G06866701Courtesy of SUZUKI OF AMERICA CORP.
  3. Turn ignition switch to ON position and confirm that only any of DTC(s) C1075 is detected. If any other DTC are detected, repair the detected DTC.
  4. Park and level the vehicle with parking brake, stop engine with ignition switch ON, set steering in straight and without stepping on the brake pedal.
    NOTE: Hold the above condition in Step  4) to calibrate sensor correctly until sensor calibration is completed.
  5. Select menu "Sensor Calibration" under "Utility" mode of SUZUKI scan tool and calibrate sensor. Refer to scan tool operators manual for further details.
  6. After completing the calibration, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
scientia non olet · About LEMON Manuals