ESP® Control Module
The parameter data below are values measured with the SUZUKI scan tool when the normally operating vehicle is under the following conditions. When taking measurements for comparison by using the SUZUKI scan tool, be sure to check that the vehicle is under the following conditions:
- Parking brake is applied and wheels are blocked.
- Ignition switch is at ON position.
- Air conditioner is turned OFF (if equipped).
- No load is applied to power steering (if equipped). (Do not turn it)
- Set the wheel in straight-ahead position and hands off steering wheel.
- All electric loads are turned OFF (except ignition).
- No DTC is detected.
SCAN TOOL DATA
| Scan Tool Data | Standards | Condition |
|---|---|---|
| RF Wheel Speed Sensor | 0 km/h | Vehicle is in stationary condition |
| LF Wheel Speed Sensor r | ||
| RR Wheel Speed Sensor | ||
| LR Wheel Speed Sensor | ||
| Battery Voltage | 10.0 - 16.0 V | Ignition switch ON (Engine at stop) |
| Brake Switch | ON | Brake pedal is depressed |
| OFF | Brake pedal is released | |
| Master Cyl Press | 0 ± 0.8 MPa | Brake pedal is released |
| G Sensor (Lateral) | 0 ± 0.1 G | Parking (Ignition Switch ON, On the level) |
| 0 ± 0.1 G or more | Right turning | |
| 0 ± 0.1 G or less | Left turning | |
| Yaw Rate Sensor | 0 ± 4 deg/s | Parking (Ignition Switch ON, On the level) |
| 0 ± 4 deg/s or more | Right turning | |
| 0 ± 4 deg/s or less | Left turning | |
| Steering Angle Sen | 0 ± 3 deg | Front wheels are in straight-ahead position |
| 360 ± 3 deg | Rotate steering wheel a round in clockwise | |
| -360 ± 3 deg | Rotate steering wheel a round in counterclockwise | |
| Engine Speed | 0 RPM | Engine at stop with ignition switch turned ON |
| Steering Angle Sig | Neutral | Front wheels are in straight-ahead position |
| Non-N | Front wheels are not in straight-ahead position | |
| ESP® Off State (Cont) | ON | ESP® is cancel |
| OFF | ESP® is available | |
| Inlet Solenoid RF | ON | Right-Front inlet solenoid valve is energized |
| OFF | Right-Front inlet solenoid valve is not energized | |
| Outlet Solenoid RF | ON | Right-Front outlet solenoid valve is energized |
| OFF | Right-Front outlet solenoid valve is not energized | |
| Inlet Solenoid LF | ON | Left-Front inlet solenoid valve is energized |
| OFF | Left-Front inlet solenoid valve is not energized | |
| Outlet Solenoid LF | ON | Left-Front outlet solenoid valve is energized |
| OFF | Left-Front outlet solenoid valve is not energized | |
| Inlet Solenoid RR | ON | Right-Rear inlet solenoid valve is energized |
| OFF | Right-Rear inlet solenoid valve is not energized | |
| Outlet Solenoid RR | ON | Right-Rear outlet solenoid valve is energized |
| OFF | Right-Rear outlet solenoid valve is not energized | |
| Inlet Solenoid LR | ON | Left-Rear inlet solenoid valve is energized |
| OFF | Left-Rear inlet solenoid valve is not energized | |
| Outlet Solenoid LR | ON | Left-Rear outlet solenoid valve is energized |
| OFF | Left-Rear outlet solenoid valve is not energized | |
| Cut Solenoid No. 1 | ON | No. 1 cut solenoid valve is energized |
| OFF | No. 1 cut solenoid valve is not energized | |
| Cut Solenoid No. 2 | ON | No. 2 cut solenoid valve is energized |
| OFF | No. 2 cut solenoid valve is not energized | |
| Suction Solenoid No. 1 | ON | No. 1 suction solenoid valve is energized |
| OFF | No. 1 suction solenoid valve is not energized | |
| Suction Solenoid No. 2 | ON | No. 2 suction solenoid valve is energized |
| OFF | No. 2 suction solenoid valve is not energized | |
| Pump Motor Driver | OFF | Vehicle is in stationary condition |
| Brake Fluid Level | Enough | Brake fluid level is filled |
| No Engh | Brake fluid level is lower than minimum level | |
| Valve Power Driver | ON | Ignition switch ON |