ESP® Control Module
As the data values are standard values estimated on the basis of values obtained from the normally operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good condition, there may be cases where the checked value does not fall within each specified data range. Therefore, judgment as abnormal should not be made by checking with these data alone.
NOTE:
Ignition mode stands for power supply mode according to engine switch operation in keyless push start system.
SCAN TOOL DATA AND VEHICLE CONDITION CHART
| Scan tool data | Vehicle condition | Condition/reference values |
|---|---|---|
| Battery Voltage | Ignition mode ON (Engine at stop) | 13.0 - 15.0 V |
| Pump Motor Driver | Inactive (Pump motor is not working) | 0.0 V |
| Active (Pump motor is working) | 13.0 - 15.0 V | |
| RF Wheel Speed | At stop (Vehicle is in stationary condition) | 0 km/h (0 mph) |
| LF Wheel Speed | At stop (Vehicle is in stationary condition) | 0 km/h (0 mph) |
| RR Wheel Speed | At stop (Vehicle is in stationary condition) | 0 km/h (0 mph) |
| LR Wheel Speed | At stop (Vehicle is in stationary condition) | 0 km/h (0 mph) |
| Brake Switch | Depressed brake pedal | ON |
| Released brake pedal | OFF | |
| Master Cyl Press | Depressed brake pedal | over 0 ± 0.8 MPa |
| Released brake pedal | 0 ± 0.8 MPa | |
| G Sensor (Lateral) | Parking (Ignition mode ON, On the level) | 0 G |
| Right turning | -0.1 G | |
| Left turning | 0.1 G | |
| G sensor (In front and behind) | Parking (Ignition mode ON, On the level) | 0 G |
| Accelerating | 0.1 G | |
| Decelerating | -0.1 G | |
| Yaw Rate Sensor | Parking (Ignition mode ON, On the level) | 0 ± 4 deg/s |
| Right turning | 0 ± 4 deg/s or more | |
| Left turning | 0 ± 4 deg/s or less | |
| Steering Angle Sen | Front wheels are in straight-ahead position | 0 ± 3° |
| Rotate steering wheel once in clockwise | 360° ± 3° | |
| Rotate steering wheel once in counterclockwise | -360° ± 3° | |
| ESP® OFF SW State | ESP® OFF switch button is released | OFF |
| ESP® OFF switch button is pushed | ON | |
| Steering Angle Sig | Front wheels are in straight-ahead position (-5° to 5°) | Neutral |
| Other than above condition, or not calibrated | Not N | |
| Stability Control | Operating | ON |
| Not operating | OFF | |
| Hill Hold Control | Active brake is applied to vehicle on up slope | ON |
| Other than above condition | OFF | |
| TCSS Control (Brake) | Active brake is applied to wheel | ON |
| Other than above condition | OFF | |
| TCSS Control (Engine) | Engine torque control is operating | ON |
| Other than above condition | OFF |