- Check that the vehicle firmware is at least 2023.20 or later. If it is not perform a firmware update. See FIRMWARE UPDATE
.
- If no pull tab is present, remove the key fob cover and battery from the key fob assembly.
- Use a multimeter to confirm battery voltages on new fob keys are sufficient for procedure.
NOTE:
Battery voltages of new keys should be 2.9V or greater.
NOTE:
Do not re-insert the battery until after starting the toolbox routine at a later step.
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect And Disconnect)
.
NOTE:
Configuration changes from within Toolbox can only be performed by a Tesla employee at this time. Third parties must request the configuration change through their agreed Tesla technical support channel.
- In Toolbox 3, select the Actions
tab, type "pairing" into the search field, click PROC_BCCEN_X_AUTOPAIRING, click Run
, and follow the prompts in Toolbox to program the key(s).
NOTE:
Note If Bluetooth connectivity is poor, triple clicking the frunk button forces the key fob to broadcast.
- Inspect key fob function with at least two functional keys present and paired. Check the lock/unlock and trunk/frunk release functions.
- On the touchscreen, touch Controls > Service Mode > Exit Service Mode
.
- Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect And Disconnect)
.