Camera - Rear View - Remove And Replace: Installation

Installation procedure is the reverse of removal, except for the following:

CAUTION: Follow the directions in the installation section of the liftgate applique procedure to ensure proper adhesion Applique - Liftgate (Remove And Replace) .

Verify the rear-view camera operation.
1. Connect a laptop with Toolbox 3 to the vehicle.
2. Go to Dashboards > Service Tools > DAS Clear Calibration > Clear Calibration Backup .
3. Go to Dashboards > Service Tools > View DAS images > Image Capture .
4. Verify that the newly installed camera is able to capture the image by looking at the view for the rear-view camera.