LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1991 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing - 6-CYL >> Ignition Checks (Supra Turbo) >> IGNITOR Test (Supra Turbo) >> Ignitor Power Transistor Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignitor Power Transistor Check

  1. Turn ignition off. Unplug ignition module 4-pin connector. Disconnect each ignition coil pack 2-pin connector. Turn ignition on. Connect ohmmeter between terminal No. 2 of third ignition coil and ground. See Fig 1
  2. Using a 3-volt dry cell battery, apply 3 volts to terminal No. 2 of 4-pin connector. With 3 volts applied, ensure ohmmeter indicates momentary continuity. Connect ohmmeter between terminal No. 2 of first ignition coil and ground.
  3. Apply 3 volts to terminal No. 4 of 4-pin connector. With 3 volts still applied to terminal No. 4, also apply 3 volts to terminal No. 2. Ensure ohmmeter indicates momentary continuity. See Fig 1t ohmmeter between terminal No. 2 of second ignition coil and ground.
  4. Apply 3 volts to terminal No. 3 of 4-pin connector. With 3 volts still applied to terminal No. 3, also apply 3 volts to terminal No. 2. Ensure ohmmeter indicates momentary continuity. See Fig 1e ignitor if tests are not as specified.
Fig 1: Testing Ignitor (Supra Turbo)
G118585Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals