Clearing Codes
- After repairs are performed, clear ECU memory of all stored codes. To clear memory, turn ignition off. Remove proper fuse from main fuse block for approximately 30 seconds or more. See MAIN FUSE BLOCK LOCATION table. See CLEARING CODES table for proper fuse to be removed.
- Depending on ambient temperature, fuse may need to be removed for more than 30 seconds. (Colder temperatures require longer time.) Install fuse and enter diagnostic mode to check for any codes that may not have cleared.
- Codes can also be cleared by disconnecting vehicle battery. However, other memory functions (clock, radio, alarm, seats, etc.) will need to be reset.
MAIN FUSE BLOCK LOCATION
| Application | Location |
|---|---|
| Paseo | In Engine Compartment Fuse/Relay Box |
CLEARING CODES
| Application | Fuse (Amperage) |
|---|---|
| Paseo | EFI (15) |