Removal & Installation
WARNING: This page is about the Pickup Base, G58, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| RWD,In-Line4,5 Spd Trans,Gas | 3.6 | C | ||
| Combination Procedure: BEARING RETAINER SEAL: Remove & Replace: | ||||
| 0.4 | B | |||
| Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: EXTENSION HOUSING SEAL: Remove & Replace: | ||||
| 0.1 | B | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: INPUT SHAFT BEARING: Remove & Replace: | ||||
| 5 Spd Trans, Front | 1.8 | A | ||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul: | ||||
| In-Line4, RF1A Type Transfer | 4.4 | A | ||
| In-Line4, VF1A Type Transfer | 5.5 | A | ||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| 0.4 | C | |||