Code Detection Test Drive
- Ensure ignition is off. Remove EFI (15-amp) fuse for at least 10 seconds. Reinstall fuse. Start engine and warm to normal operating temperature.
- Allow engine to idle for 3 minutes. Turn on A/C. Place vehicle in "D" (A/T) or 1st gear (M/T). Accelerate vehicle with engine speed at 1300-1700 RPM (constant) until vehicle speed of 40-50 MPH is achieved. If vehicle is equipped with manual transmission, DO NOT allow engine speed to fall below 1200 RPM while shifting through gears.
- Maintain vehicle speed for at least 1-2 minutes. Stop vehicle and turn ignition off for at least 3 seconds. Start vehicle and accelerate with engine speed at 1300-1700 RPM (constant) until vehicle speed of 40-50 MPH is achieved. If vehicle is equipped with manual transmission, DO NOT allow engine speed to fall below 1200 RPM while shifting through gears.
- Maintain vehicle speed for at least 1-2 minutes. If malfunction exists, MIL will illuminate after approximately one minute from start of 2nd acceleration.