A/T Models
- Disconnect electrical connector from Park/Neutral Position (PNP) switch, mounted on side of transmission/transaxle. Note terminal identification. See Fig 1 and Fig 2.
- Using ohmmeter, check for continuity between specified terminals with shift lever in proper positions. See PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS table. If proper continuity cannot obtained, adjust or replace switch as necessary.
PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS
| Shift Lever Position | Terminal Continuity | |
|---|---|---|
| 2WD | ||
| Park | 2 & 3; 1 & 6 | |
| Reverse | 5 & 6 | |
| Neutral | 2 & 3; 6 & 7 | |
| Drive | 6 & 8 | |
| 2 | 6 & 9 | |
| Low | 4 & 6 | |
| 4WD | ||
| Park | 5 & 6; 2 & 7 | |
| Reverse | 2 & 8 | |
| Neutral | 5 & 6; 2 & 9 | |
| Drive | 2 & 10 | |
| 2 | 2 & 3 | |
| Low | 2 & 4 | |