DTC P1129: Electronic Throttle Control System Circuit: Notes

NOTE: DTC applies only to 2001 models with sequential manual transaxle. Sequential manual transaxle is an electronically controlled manual transaxle in which the clutch is operated and transaxle is shifted hydraulically by moving the shift lever forward or backward. Sequential manual transaxle may be identified by shift lever pattern which consists of "R", "N", "S" and "+" in place of the conventional type shift lever pattern and no clutch pedal is used.

CAUTION: If ECM replacement is instructed in following testing, always ensure ECM connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.