Circuit Description
Park/Neutral Position (PNP) switch sends a signal to ECM when transaxle is in Neutral or Park. This signal is used for air/fuel correction and for idle speed control. DTC is set when 2 or more switches are on simultaneously for "R", "N", "2" and "L" position, or ECM is receiving an ON signal from PNP switch when vehicle is being operated for more than 30 seconds at 44 MPH or more (1500-2500 RPM). Possible causes are:
- PNP switch circuit is shorted.
- Defective PNP switch.
- Defective ECM.