Horn Relay
- Ensure ignition is off. Remove horn relay. Horn relay is located in fuse/relay box at driver's side of instrument panel. See Figure and Fig 1
.
- Note identification of electrical terminals on horn relay. See Fig 2. Using ohmmeter, check that no continuity exists between terminals No. 3 and 5 on horn relay. Check that continuity exists between terminals No. 1 and 2 on horn relay.
- Using jumper wires, apply battery voltage and ground to terminals No. 1 and 2 on horn relay. Check that continuity now exists between terminals No. 3 and 5 on horn relay. See Fig 2. Replace horn relay if defective.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002