Deceleration Sensor Zero Point Calibration
NOTE:
Perform zero point calibration of yaw rate sensor first. See YAW RATE SENSOR ZERO POINT CALIBRATION .
- Using Diagnosis Check Wire (09843-18020), connect terminals Ts and E1 of DLC1. See Fig 1.
- Turn the ignition switch ON. Ensure the vehicle is in a stationary condition with the shift lever in P.
- Check that the VSC warning light is lit for about 4 seconds and then starts quickly blinking at 0.13 second intervals.
- After confirming the blinking of VSC warning light for 2 seconds, turn the ignition switch OFF.
- Remove the special tool.