Power Window Control System: Troubleshooting

One touch power window does not move up and down. (Prepare normal master switch) .

Fig 1: Displaying Troubleshooting Flow Chart 1 (1 Of 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Displaying Troubleshooting Flow Chart 1 (2 Of 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
During AUTO UP operation, the power window moves down .

Fig 3: Displaying Troubleshooting Flow Chart 2
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

^* 1 Resetting method of the motor for jam protection.
The DOWN function does not work though some other objects are caught in the power window glass.

Fig 4: Displaying Troubleshooting Flow Chart 3
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

^*2 Resetting method of the motor for jam protection.
NOTE:
- When cutting the motor away from the regulator or raising the motor, make sure to rest the motor.
- This is the operation to set limit switch at "OFF".
  1. Connect the motor to the vehicle side harness.
  2. Rotate the motor to the rising direction for 4 - 5 sec.
NOTE: Rotating the motor for 4-5 secs. sets the limit switch at"OFF". (Top dead center of the door glass).
1. Move the window to the fully closed position. (perform this by manual operation).
2. Using the bar with 2mm, press the reset switch.
3. With the reset switch pressed, move the window to the fully opened position with the master switch. (Perform this by manual operation).
4. Remove the bar from the reset switch, move the window to the fully closed position.