Testing Procedure
To ensure correct diagnosis and repair, testing should be done in following sequence:
- Record Customer Complaint
Ensure all customer complaints or observations are recorded. Test drive vehicle with customer when necessary for malfunction verification. - DLC3 Inspection
Connect hand-held tester to DLC3. See Fig 1. If display indicates a communication fault in tool, inspect DLC3. See DATA LINK CONNECTOR NO. 3 INSPECTION under SCAN TOOL PROBLEMS. - Retrieve DTCs & Freeze Frame Data
Retrieve diagnostic trouble codes (DTCs) and record any freeze frame data (if applicable). See RETRIEVING DIAGNOSTIC TROUBLE CODES and FREEZE FRAME DATA . - Clear DTCs & Freeze Frame Data
Clear DTCs and freeze frame data. See CLEARING DIAGNOSTIC TROUBLE CODES . - Visual Inspection
Inspect all connectors of suspect circuit or component. Ensure all connections are clean and tight. - Check Mode Diagnosis
Set check (test) mode diagnosis. See CHECK MODE CODE RETRIEVAL under RETRIEVING DIAGNOSTIC TROUBLE CODES. - Confirm Symptoms
Perform road test. Determine if original symptoms are still present. If engine does not start, perform steps 8 and 9 first. If a malfunction does not occur, simulate symptom and go to next step. If a malfunction occurs, go to next step. - DTC Check
Check DTC. See SYSTEM OVERVIEW . If there is no code, go to next step. If there is a malfunction code, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS , then step 11. - Basic Inspection
Perform basic inspection. See BASIC INSPECTION . If results are OK, go to next step. If results are not good, inspect parts and then proceed to step 14. - Determine Symptom
Determine problem symptoms. See SYMPTOM DIAGNOSIS under SYMPTOMS in TROUBLE SHOOTING - NO CODES article. If problem is in circuit, go to next step. If problem is in parts, inspect parts and go to step 14. - Inspect ECM Power Source Circuit
Check ECM power source circuit. See SYSTEM & COMPONENT TESTING - 4-CYLINDER article. - Inspect Circuit
Perform appropriate circuit test. See DIAGNOSTIC TESTS . If circuit is OK, go to step 14. If circuit is not good, go to next step. - Intermittent Problems Check
Check for intermittent problems. See INTERMITTENT PROBLEM CHECK . - Verification Procedure
After repairs have been completed, clear all DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES . Perform road test. Ensure no DTCs are present and all symptoms and/or complaints have been repaired.