LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> RAV4 Base, FWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self Diagnostics >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> CHECK Mode Diagnostic Trouble Code Retrieval
April 5, 2026: LEMON Manuals is launched! Read the announcement.

CHECK Mode Diagnostic Trouble Code Retrieval

NOTE: If using Toyota hand-held tester, if ignition switch is turned from ON to ACC or OFF position during CHECK mode, all DTCs and freeze frame data will be erased from ECM. DO NOT switch from CHECK mode to NORMAL mode until all DTCs and freeze frame data are recorded.
  1. Ensure vehicle battery is fully charged. Apply parking brake. Place transaxle in Park or Neutral. Ensure A/C and ignition are off. Check that throttle valve is fully closed. Connect Toyota hand-held tester to Data Link Connector No. 3 (DLC3) at driver's side of instrument panel. See Figure. Turn ignition on and then turn hand-held tester on.
  2. Switch hand-held tester from NORMAL mode to CHECK mode. Ensure Malfunction Indicator Light (MIL) on instrument cluster flashes to indicate CHECK mode operation. Start engine. If no DTCs are present, MIL will turn off. Try to simulate conditions of driveability complaint described by customer.
  3. Record any DTCs and freeze frame data displayed for system diagnosis. If driveability problem exist and no DTCs are present, go to TROUBLESHOOTING - NO CODES article for diagnosis by symptom.
  4. If any DTCs are present, perform appropriate DTC test under DIAGNOSTIC TESTS . For DTC descriptions, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . For information on freeze frame data, see FREEZE FRAME DATA . For information on two-trip detection logic DTCs, see TWO-TRIP DETECTION LOGIC .
  5. After repairs for DTC have been completed, DTC must be cleared from ECM. See CLEARING DIAGNOSTIC TROUBLE CODES . Road test vehicle to ensure all symptoms and/or complaints have been repaired.