Speed Sensor Front LH: Replacement

HINT: Replace the RH side by the same procedure as the LH side.

1. REMOVE FRONT WHEEL 
2. REMOVE FRONT FENDER LINER LH 
3. REMOVE SPEED SENSOR FRONT LH 
   1. Disconnect the speed sensor wire harness clamp from the body.
   2. Disconnect the speed sensor connector.
      Fig 1: Disconnecting Speed Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
      Fig 2: Removing Clamp Bolts Holding Sensor Harness From Body And Shock Absorber

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the bolt and speed sensor front LH.
   NOTE: Keep on the sensor tip clean.
   Fig 3: Removing Speed Sensor Front LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL SPEED SENSOR FRONT LH 
   1. Install the speed sensor front LH with the bolt.

      Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf) 

      NOTE: Make sure the sensor tip is clean.
      Fig 4: Installing Speed Sensor Front LH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the sensor harness clamp with the 2 bolts "A" and "B" to the body and shock absorber.

      Torque: 

      Bolt A: 8.0 N.m (82 kgf.cm, 71 in.lbf) 

      Bolt B: 29 N.m (296 kgf.cm, 21 ft.lbf) 

      Fig 5: Installing Sensor Harness Clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Connect the speed sensor connector.
   4. Connect the speed sensor wire harness clamp to the body.
      Fig 6: Connecting Speed Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT FENDER LINER LH 
6. INSTALL FRONT WHEEL 

   Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf) 

7. CHECK ABS SPEED SENSOR SIGNAL (See  COMBINATION METER  )