Fuel Pump: Installation

Install the pump filter with a new clip.

Fig 1: Installing Pump Filter

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the rubber cushion to the fuel pump.
2. Connect the fuel hose to the outlet port of the fuel pump.
3. Install the fuel pump by pushing the lower side of the fuel pump.

1. Install a new gasket to the fuel suction plate.
2. Insert the fuel pump and the sender gauge assembly into the fuel tank.
3. Install the fuel tank vent tube set plate with the 8 bolts.

   Torque: 3.5 N.m (35 kgf.cm, 31 in.lbf) 

   Fig 2: Installing Fuel Pump And Sender Gauge Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Before installing the tube connectors, check foreign matters on the connection between the nylon tube and the suction plate.
   Fig 3: Checking Foreign Matters On Connection Between Nylon Tube And Suction Plate

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the fuel tube connectors to the ports of the fuel suction plate and insert the clips until you hear a click.
3. After the connection, pull out the clips to check to see that they are installed securely.
   Fig 4: Pulling Out Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the rear service hole cover with the 2 screws.
2. Cover the rear and front floor carpets.