LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2006 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System And Component Testing >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

  1. INSTALL KNOCK CONTROL SENSOR 
    1. Install the 2 knock sensors with the 2 nuts, as shown in Fig 1 .

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Connect the 2 knock sensor connectors.
    Fig 1: Installing Knock Control Sensor
    G04435549Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR PUMP ASSEMBLY (See  REASSEMBLY  ) 
  3. INSTALL INTAKE MANIFOLD ASSEMBLY (See  INSTALLATION  ) 
  4. CONNECT FUEL MAIN HOSE (See  INSTALLATION  ) 
  5. CONNECT FUEL RETURN HOSE (See  INSTALLATION  ) 
  6. INSTALL INTAKE AIR CONNECTOR PIPE (See  INSPECTION PROCEDURE   ) 
  7. INSTALL V-BANK COVER SUB-ASSEMBLY (See  INSPECTION PROCEDURE   ) 
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  10. ADD ENGINE COOLANT (See  COOLANT  ) 
  11. CHECK FOR ENGINE COOLANT LEAKS 
    1. Check for engine coolant leaks (see ON-VEHICLE INSPECTION ).
  12. CHECK FOR FUEL LEAKS 
    1. Check for fuel leaks (see ON-VEHICLE INSPECTION ).
scientia non olet · About LEMON Manuals