Inspection Procedure
NOTE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (see INITIALIZATION
).
- CHECK DTC (HYBRID CONTROL SYSTEM)
- Check if a hybrid control system DTC is output (see
DIAGNOSTIC TROUBLE CODE CHART
).
Result
RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B : REPAIR HYBRID CONTROL SYSTEM
OK
- Check if a hybrid control system DTC is output (see
DIAGNOSTIC TROUBLE CODE CHART
).
- CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
- Check if C1300/- is output.
Result
RESULT REFERENCEResult Proceed to C1300/- is not output A C1300/- is output B
B : GO TO DTC C1300
A : REPLACE SKID CONTROL ECU
- Check if C1300/- is output.