Repair Instruction: Initialization

SYSTEM REFERENCE

System Name
Power Window Control System

RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR (DRIVER SIDE)
NOTE:
- Resetting the power window regulator motor (initializing the pulse sensor) is necessary if one of the following occurs: 1) the battery cable is disconnected; 2) the power window regulator master switch, wire harness, power window regulator switch, power window regulator or power window regulator motor is replaced or removed / installed; or 3) the Power fuse, FR Door fuse, GAUGE fuse and ECU-IG fuse are replaced. If resetting is not performed, the master switch will not be able to operate the AUTO UP / DOWN function, jam protection function and remote operation function.
- Whenever disconnecting the cable from the negative (-) battery terminal, reset all the other systems besides the power window control system.
1. Change the power mode to ON (IG) by pushing the power switch.
2. Open the power window halfway by pressing the power window switch.
3. Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
4. Check that the AUTO UP / DOWN function operates normally.
  If the AUTO UP / DOWN function operates normally, reset operations are complete. If abnormal, follow the 3 steps below.
5. Disconnect the cable from the negative (-) battery terminal for 10 seconds.
6. Connect the cable to the negative (-) battery terminal.
7. Perform the first 4 steps again.
  If the AUTO UP / DOWN function operates normally, reset operations have been completed at this time. If abnormal, follow the 4 steps below.
8. Change the power mode to ON (IG) by pushing the power switch.
9. Open the power window halfway by pressing the power window switch.
10. Fully pull up on the switch until the power window is fully closed and continue to hold the switch for approximately 12 seconds after the power window is fully closed.
11. Check that the AUTO UP / DOWN function operates normally.