Diagnostic Trouble Code Chart
If a trouble code is displayed during the DTC check, check the circuit listed for that code in the table below and proceed to the appropriate page.
HINT:
- When the DTC C2300, C2301, C2304, C2305, C2306, C2307, C2311 and C2312 are detected, DTC P3102 indicating the electronic shift lever system malfunctions are detected for the hybrid system as well. Because of this, the hybrid system DTCs must be cleared after clearing the electronic shift lever system DTCs.
- Remove the P CON MAIN fuse to erase DTCs C2300, C2301, C2303, C2304, C2305, C2306 and C2307 because they cannot be erased with the intelligent tester.
- When a DTC is detected, the master warning light comes on and an error message is indicated on the multi-display.
- The indicator blinks quickly when it takes a long time to switch between the P position status and the P position release status.
DIAGNOSTIC TROUBLE CODE REFERENCE
| DTC No. | Detection Item | Trouble Area | P Position Switch Indicator Light Condition | HINT |
|---|---|---|---|---|
| C2300 | ACT System Malfunction |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2301 | Shift Changing Time Malfunction |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2303 | Relay Malfunction (+B Short) |
|
Normal
|
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2304 | Open or Short Circuit in "U" Phase |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2305 | Open or Short Circuit in "V" Phase |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2306 | Open or Short Circuit in "W" Phase |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2307 | Power Source Malfunction |
|
Blinks slowly | If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first. |
| C2310 | Open or Short Circuit in BATT |
|
Normal
|
- |
| C2311 | HV Communication Line Malfunction |
|
Blinks slowly | - |
| C2312 | Power Source Control ECU Communication Line Malfunction |
|
Normal
|
- |
| C2315 | HV System Malfunction |
|
Normal
|
- |
| C2318 | Low Voltage Error (Power Supply Malfunction) |
|
Normal
|
- |