Crankshaft Position Sensor: Installation

1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
2. Install the crankshaft position sensor with the bolt.

   Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf) 

3. Connect the crankshaft position sensor connector.
   Fig 1: Identifying Crankshaft Position Sensor Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the cooler compressor assembly with the 4 bolts.

   Torque: 24.5 N*m (250 kgf*cm, 18 ft.*lbf) 

2. Connect the cooler compressor assembly connector.
   Fig 2: Identifying Cooler Compressor Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the suction hose sub-assembly with the bolt.

   Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

Refer to the procedures up to "INSTALL GENERATOR ASSEMBLY" (See INSTALLATION )

Refer to the procedures up to "INSTALL FAN" (See INSTALLATION ).

Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

Fig 3: Identifying Bolt

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002