Crankshaft Position Sensor: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE V-BANK COVER (See REMOVAL )
REMOVE FAN
Refer to the procedures up to "REMOVE FAN" (See REMOVAL ).
REMOVE GENERATOR ASSEMBLY
Refer to the procedures up to "REMOVE GENERATOR ASSEMBLY" (See REMOVAL )
SEPARATE COOLER COMPRESSOR ASSEMBLY
1. Remove the bolt, then separate the suction hose sub-assembly.
  
  Fig 1: Identifying Suction Hose Sub-Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cooler compressor assembly connector.
3. Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
  
  Fig 2: Identifying Cooler Compressor Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CRANKSHAFT POSITION SENSOR
1. Disconnect the crankshaft position sensor connector.
2. Remove the bolt, then remove the crankshaft position sensor.
  
  Fig 3: Identifying Crankshaft Position Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002