Inspection Procedure

HINT:

Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

1. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SW) 
   1. Connect an intelligent tester to the DLC3.
   2. Turn the ignition switch ON and turn the tester ON.
   3. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / STOP LIGHT SW.
   4. Read the values displayed on the tester.

      OK 

      DIAGNOSTIC PROCEDURE
      
      

      Item	Measurement Item: Range (display)	Normal Condition
      STOP LIGHT SW	Stop light switch status: ON or OFF	ON: Brake pedal Is depressed OFF: Brake pedal is released

   OK: CHECK FOR INTERMITTENT PROBLEMS 

   NG: Go TO NEXT STEP 

2. INSPECT STOP LIGHT SWITCH ASSEMBLY  (See INSPECTION PROCEDURE  )

   NG: REPLACE STOP LIGHT SWITCH ASSEMBLY  (See REMOVAL )

   OK: Go TO NEXT STEP 

3. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - ECM)  (See INSPECTION PROCEDURE  )

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   OK: REPLACE ECM  (See REMOVAL  )