Inspection Procedure

HINT:

Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) 
   1. Connect an intelligent tester to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   5. Read DTCs.

      Result 

      DTC RESULT DESCRIPTION
      
      

      Display (DTC Output)	Proceed To
      P2119	A
      P2119 and other DTCs	B

      HINT:

      If any DTCs other than P2119 are output, troubleshoot those DTCs first.

   B: GO TO  DIAGNOSTIC TROUBLE CODE TABLE  

   A: Go TO NEXT STEP 

2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) 
   1. Connect an intelligent tester to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Clear DTCs (See DTC CHECK/CLEAR  ).
   5. Allow the engine to idle for 15 seconds.
      CAUTION: Exercise extreme care and take precautions at steps ( f) and ( g) below. Failure to do so may result in the vehicle unexpectedly rotting away.
   6. Securely apply the parking brake and move the gear selector lever to the D position.
   7. While depressing the brake pedal securely, fully depress the accelerator pedal for 5 seconds.
   8. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   9. Read DTCs.

      HINT:

      The voltage output of the throttle position sensor can be checked during step ( g) using an intelligent tester. Variations in the voltage output indicate that the throttle actuator is in operation. To check the voltage output using an intelligent tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / THROTTLE POS#1.

      OK: 

      No DTC output. 

   NG: REPLACE THROTTLE WITH MOTOR BODY ASSEMBLY  (See REMOVAL  )

   OK: CHECK FOR INTERMITTENT PROBLEMS