Camshaft Position Sensor: Installation

INSTALL CAMSHAFT POSITION SENSOR
1. Install the camshaft position sensor with the bolt and stud bolt.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY BANK 1 (See INSTALLATION )
CONNECT NO. 1 RADIATOR HOSE (See INSTALLATION )

Fig 1: Locating Bolt, Stud Bolt And Camshaft Position Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR CONNECTOR PIPE (see INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform INITIALIZATION .
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKS
1. Check for engine coolant leaks (see REPLACEMENT ).