Inspection Procedure

1. Turn the ignition switch ON.
2. Measure the voltage of the ECM connectors.

Standard voltage 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON  PROBLEM SYMPTOMS TABLE  

Fig 1: Checking ECM (+B Voltage)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: GO TO Next Step 

1. Disconnect the E7 ECM connector.
2. Measure the resistance of the wire harness side connector.

Standard resistance 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Disconnecting E7 ECM Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Turn the ignition switch ON.
2. Measure the voltage of the ECM connectors.

Standard voltage 

OK: GO TO step   6

Fig 3: Checking ECM (IGSW Voltage)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: GO TO Next Step 

1. Remove the IGN fuse from the cowl side junction block RH.
2. Measure the resistance of the IGN fuse.

Standard resistance: Below 1 Ω 

NG: CHECK FOR SHORT IN ALL HARNESSES AND COMPONENTS CONNECTED TO IGN FUSE, AND REPLACE IGN FUSE 

Fig 4: Identifying IGN Fuse

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Remove the 118 ignition switch connector.
2. Measure the resistance of the ignition switch.

Standard resistance 

NG: REPLACE IGNITION SWITCH ASSEMBLY 

Fig 5: Inspecting Ignition Switch Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - IGNITION SWITCH, IGNITION SWITCH - ECM) 

1. Turn the ignition switch ON.
2. Measure the voltage of the ECM connectors.

Standard voltage 

NG: REPLACE ECM 

Fig 6: Checking ECM (MREL Voltage)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Remove the EFI OR ECD NO. 1 fuse from the engine room junction block.
2. Measure the resistance of the EFI OR ECD NO. 1 fuse.

Standard resistance: Below 1 Ω 

NG: CHECK FOR SHORT IN ALL HARNESSES AND COMPONENTS CONNECTED TO EFI OR ECD NO. 1 FUSE, AND REPLACE EFI OR ECD FUSE 

Fig 7: Identifying EFI Or ECD NO. 1 Fuse

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Remove the EFI relay from the engine room relay block.
2. Measure the resistance of the EFI relay.

Standard resistance 

NG: REPLACE EFI RELAY 

Fig 8: Inspecting EFI Relay

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Check harness and connector (see ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).

OK: REPAIR OR REPLACE HARNESS OR CONNECTOR 

NG: CHECK AND REPLACE HARNESS OR CONNECTOR (TERMINAL +B OF ECM - POSITIVE BATTERY TERMINAL)