LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Matrix Base, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Meter >> Meter / Gauge System >> Customize Parameters
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters

  1. SEAT BELT BUZZER ON/OFF SETTING 
    1. Check that the ODO display is on, and turn the ignition switch off and then on. If other display is on, change it to the ODO display.
    2. Within 2 to 6 seconds after turning the ignition switch ON, push the ODO/TRIP switch and hold it for 10 seconds or more.
    3. Following the table below, set the seat belt buzzer ON/OFF setting.
      BUZZER OPERATION

      Buzzer Operation
      Driver side seat belt buzzer Front seat inner belt assembly (Driver side) OFF → ON (Seat belt unfastened → fastened)
      Buzzer Operation
      Front passenger seat belt buzzer Sit on the front passenger seat and front seat inner belt assembly
      (front passenger side) OFF → ON
      (Seat belt unfastened → fastened)

      HINT:

      The ODO/TRIP display changes from "b-on" to "b- off", entering the cancel mode.

    4. During the cancel mode, each time the ODO/TRIP switch is pushed, the setting is switched between *1 b-on and *2 b-off.

      HINT:

      *1 b-on: Cancel is invalid

      *2 b-off: Cancel is valid

    5. After the setting, the mode will be canceled by either not operating the switch for 10 seconds or more, or turning the ignition switch from ON to OFF.

      HINT:

      The setting can be reset when reconnecting the battery connector or removing/installing the meter connector (Buzzer on).

scientia non olet · About LEMON Manuals