LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Matrix Base, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt >> Rear Seat Outer Belt Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Seat Outer Belt Assembly: Installation

  1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY 
    NOTE: Do not disassemble the retractor.
    1. Before installing the ELR, check the ELR.
      1. Gently tilt the ELR and pull the belt. Check that the belt will not lock within 15° of tilt in all directions Then check that the belt will lock when over 45° of tilt is applied. If the operation is not as specified, replace the rear seat belt assembly outer.
    2. Install the rear seat belt assembly outer (retractor side) with the bolt.

      Torque: for upper bolt 

      4.9 N*m (50 kgf*cm, 43 in.*lbf) 

      for lower bolt 

      41.2 N*m (420 kgf*cm, 30 ft.*lbf) 

      Fig 1: Identifying Belt ELR Lock Angle
      G05195797Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the rear seat belt assembly outer (floor anchor side) with the bolt.

      Torque: 41.2 N*m (420 kgf*cm, 30 in.*lbf) 

      NOTE: Do not make the anchor part run onto the protruding part of the floor panel.
    4. After installing the ELR, check the ELR.
      NOTE: The check should be performed with the assembly installed.
      1. With the belt installed, check that the belt locks when it is pulled out quickly. If the operation is not as specified, replace the rear seat belt assembly outer.
    5. Check the fastening function of the child restraint system.
      NOTE: The check should be performed with the assembly installed.
      Fig 2: Identifying Rear Seat Belt Assembly Outer Bolt Installing Angle
      G05195798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. When the belt is pulled put fully, the belt should automatically try to retract.
      2. After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the rear seat belt assembly outer.
  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH 
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH 
  4. INSTALL REAR SEAT SIDE GARNISH LH 
  5. INSTALL REAR SEAT SIDE GARNISH RH 
  6. INSTALL REAR SEAT CUSHION ASSEMBLY AND REAR SEATBACK ASSEMBLY 
  7. INSTALL DECK TRIM COVER REAR 
  8. INSTALL BACK DOOR WEATHERSTRIP 
  9. INSTALL LUGGAGE COMPARTMENT TRAY 
  10. INSTALL DECK FLOOR BOX REAR 
  11. INSTALL DECK BOARD SUB-ASSEMBLY 
  12. INSTALL DECK BOARD NO. 2 
  13. INSTALL TONNEAU COVER ASSEMBLY 
  14. INSTALL REAR DOOR OPENING TRIM LH 
  15. INSTALL REAR DOOR OPENING TRIM RH 
  16. INSTALL REAR DOOR SCUFF PLATE LH 
  17. INSTALL REAR DOOR SCUFF PLATE RH