Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air/fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2119) 
   1. Connect the intelligent tester to the DLC3.
   2. Turn the power switch ON (IG).
   3. Turn the tester ON.
   4. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   5. Read the DTCs.

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed to
      P2119	A
      P2119 and other DTCs	B

      HINT:

      If any other codes besides P2119 are output, perform troubleshooting for those DTCs first.

   B: Go to DTC CHART 

   A: Go to Next Step 

2. CHECK IF DTC OUTPUT RECURS 
   1. Clear the DTCs (see DTC CHECK / CLEAR  ).
   2. Allow the engine to idle for 15 seconds.
   3. Securely apply the parking brake, and place the shift position in D.
   4. Depress the brake pedal securely and the accelerator pedal fully for 5 seconds.
   5. Read the DTCs.

      HINT:

      Actual throttle position (TP) sensor voltage can be confirmed using the intelligent tester [DATA LIST / USER DATA /THROTTLE POS #1].

      OK: No DTC output. 

   OK: SYSTEM OK 

   NG: REPLACE THROTTLE W/ MOTOR BODY ASSEMBLY