Crankshaft Position Sensor: Removal

Refer to the procedures up to "REMOVE FAN" (See REMOVAL ).

Refer to the procedures up to "REMOVE GENERATOR ASSEMBLY" (See REMOVAL )

1. Remove the bolt, then separate the suction hose sub-assembly.
   Fig 1: Identifying Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cooler compressor assembly connector.
3. Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
   Fig 2: Identifying Cooler Compressor Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the crankshaft position sensor connector.
2. Remove the bolt, then remove the crankshaft position sensor.
   Fig 3: Identifying Crankshaft Position Sensor Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002