Inspection Procedure

HINT:

Read freeze frame data using a Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) 
   1. Connect a Techstream to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
   5. Read DTCs.

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed To
      P2119	A
      P2119 and other DTCs	B

      HINT:

      If any DTCs other than P2119 are output, troubleshoot those DTCs first.

   B: GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART  )

   A: Go to Next Step 

2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) 
   1. Connect a Techstream to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Clear DTCs (See DTC CHECK/CLEAR  ).
   5. Allow the engine to idle for 15 seconds.
   6. Fully depress and release the accelerator pedal several times quickly.
   7. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
   8. Read DTCs.

      HINT:

      The voltage output of the throttle position sensor can be checked during step (g) using a Techstream. Variations in the voltage output indicate that the throttle actuator is in operation. To check the voltage output using a Techstream, select the following menu items: Powertrain / Engine and ECT / Data List / ETCS / Throttle Position No. 1.

      OK: No DTC output. 

   NG: REPLACE THROTTLE WITH MOTOR BODY ASSEMBLY  (See REMOVAL  )

   OK: CHECK FOR INTERMITTENT PROBLEMS