Throttle Body: Installation

INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
1. Connect the No. 4 water by-pass hose to the throttle body.
2. Connect the No. 5 water by-passe hose to the throttle body.
3. Install a new gasket and the throttle with motor body with the 4 bolts.
  Torque: 11 N*m (112 kgf*cm, 9 ft.*lbf)
  
  Fig 2: Identifying Throttle With Motor Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the throttle motor connector.
5. Connect the No. 4 water by-pass hose.
6. Connect the No. 5 water by-pass hose.
INSTALL AIR CLEANER ASSEMBLY
1. Install the air cleaner onto the throttle body.
2. Connect the air cleaner hose to the air cleaner.
3. Install the air cleaner with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 4: Identifying Hose Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the mass air flow meter connector.
5. Engage the 2 wire harness clamps.
6. Connect the vacuum hose.
7. Connect the No. 2 ventilation hose.
Fig 6: Identifying Ventilation Hose No. 2
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAK (See REPLACEMENT )
INSTALL V-BANK COVER
1. Install the V-bank cover with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
  
  Fig 7: Identifying V-Bank Cover With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002