LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control/Dynamic Control Systems >> Skid Control Buzzer >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Skid Control Buzzer: Installation

  1. INSTALL SKID CONTROL BUZZER ASSEMBLY 
    1. Connect the buzzer connector.
      NOTE: Securely connect the connector.
    2. Attach the clamp to install the buzzer.
    NOTE:
    • Securely insert the clamp into the bracket.
    • If the buzzer is dropped, replace it.
    Fig 1: Identifying Skid Control Buzzer Connector
    G05629991Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 SWITCH HOLE BASE  (See INSTALLATION )
  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL  (See INSTALLATION )
  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL COWL SIDE TRIM BOARD LH  (See INSTALLATION )
  6. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
scientia non olet · About LEMON Manuals