LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control/Dynamic Control Systems >> Skid Control Buzzer >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Skid Control Buzzer: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  2. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  3. REMOVE COWL SIDE TRIM BOARD LH  (See REMOVAL )
  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL  (See REMOVAL )
  6. REMOVE NO. 1 SWITCH HOLE BASE  (See REMOVAL )
  7. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    1. Detach the clamp and remove the buzzer.
    2. Disconnect the buzzer connector.
    Fig 1: Identifying Skid Control Buzzer Connector
    G05629991Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals