Fuel Pressure Regulator: Installation

INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
1. Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator.
  NOTE:
  - Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
  - When inserting the injector, be careful not to damage the O-ring.
  Fig 1: Installing Fuel Pressure Regulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. While turning the pressure regulator left and right, install it to the delivery pipe.
3. Install the 2 bolts.
  Torque: 10 N*m (107 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Pressure Regulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the vacuum sensing hose to the pressure regulator.
  
  Fig 3: Locating Vacuum Sensing Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the No. 2 fuel tube to the pressure regulator (See FUEL SYSTEM ).
INSTALL AIR CLEANER HOSE ASSEMBLY (See INSTALLATION )

Fig 4: Locating No. 2 Fuel Tube From Pressure Regulator
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT FOR FUEL LEAK (See INSTALLATION )