Brake Actuator: Installation

INSTALL BRAKE ACTUATOR ASSEMBLY
1. Install the brake actuator with the 2 nuts to the bracket.
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
INSTALL BRAKE ACTUATOR WITH BRACKET
1. Install the actuator with bracket with the 2 bolts and nut.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
  NOTE:
  - Be careful not to damage the brake tubes and wire harness.
  - Tighten the bolts in order from 1 to 3.
  Fig 1: Identifying Brake Actuator Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the actuator connector.
  NOTE: Make sure that the lever is locked securely.
3. Using SST, connect each brake tube to correct positions of the actuator with bracket, as shown in the illustration.
  SST 09023-00101
  
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
Fig 2: Identifying Brake Tubes
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WINDSHIELD WASHER JAR ASSEMBLY
INSTALL LH HEADLIGHT ASSEMBLY
INSTALL FRONT BUMPER COVER
INSTALL FRONT FENDER LINER RH
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
FILL RESERVOIR WITH BRAKE FLUID
HINT:

BLEEDING
BLEED MASTER CYLINDER
SST 09023-00101

HINT:

BLEEDING
BLEED BRAKE LINE
HINT:

BLEEDING
CHECK FLUID LEVEL IN RESERVOIR
HINT:

BLEEDING
INSPECT FOR BRAKE FLUID LEAK
CHECK ACTUATOR WITH TECHSTREAM
HINT:

See ON-VEHICLE INSPECTION
PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (See ADJUSTMENT )
PREPARE FOR FOG LIGHT AIMING (See ADJUSTMENT )
INSPECT FOG LIGHT AIMING (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (See INSTALLATION )
PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT (See ADJUSTMENT )
PREPARE FOR HEADLIGHT AIMING (for Using a Tester) (See ADJUSTMENT )
PREPARE FOR HEADLIGHT AIMING (for Using a Screen) (See ADJUSTMENT )
INSPECT HEADLIGHT AIMING (See ADJUSTMENT )
ADJUST HEADLIGHT AIMING (See ADJUSTMENT )