Front Lower Ball Joint: Installation

INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH
1. Install the lower ball joint assembly front LH to the steering knuckle LH, tighten the castle nut.
  Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
2. Install a new cotter pin.
INSTALL FRONT AXLE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH (See INSTALLATION )
INSTALL TIE ROD END SUB-ASSEMBLY LH
INSTALL SPEED SENSOR FRONT LH (w/ ABS)
INSTALL FRONT AXLE HUB LH NUT (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT:

See ADJUSTMENT
CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)
1. Vehicle Stability Control System (See TEST MODE PROCEDURE )
2. Anti-lock Brake System (See TEST MODE PROCEDURE )